Learning Center

Plain-English guides to how each type of system works, so you can choose with confidence.

How each system works

Whole House Cartridge System: how it works

Water from your main line passes through a series of 20-inch cartridges before it reaches any tap. The first stage is a 5-micron sediment cartridge that catches rust, dirt and sand so the later stages can do their job. Carbon-based stages then reduce chlorine, tastes and odors, and higher tiers add a dedicated lead/VOC or PFAS stage. There's no tank, no backwash cycle, no drain line and no electricity.

Explore →

Whole House Tank Filter: how it works

A sediment stage protects the system, then a large media tank with KDF media and catalytic carbon reduces chlorine, chloramine, tastes and odors for city water. Because it's a tank, the media lasts much longer than a cartridge and keeps flow high for larger homes.

Explore →

Salt-Based Water Softener: how it works

Hard water carries calcium and magnesium. A softener's resin bed swaps those minerals for sodium as water passes through (ion exchange), so they can't form scale in your water heater, pipes and fixtures. The metered valve regenerates the resin with brine based on how much water you've used.

Explore →

Salt-Free Water Conditioner: how it works

Instead of removing calcium and magnesium, a salt-free conditioner changes them into microscopic crystals that are less likely to stick to pipes and fixtures. That helps reduce new scale buildup. It does not remove the minerals, so it isn't a softener.

Explore →

Filtration + Salt-Based Softener: how it works

Two systems in one. The filter tank reduces chlorine, chloramine, sediment, tastes and odors. The softener then removes calcium and magnesium through ion exchange, swapping them for sodium, which is what makes water feel soft and stops scale. A metered valve regenerates based on the water you actually use.

Explore →

Whole House UV Purification: how it works

Water flows through a 316L stainless steel chamber around a UV lamp. The UV light at 254 nm disrupts the DNA of bacteria and viruses so they can't reproduce, without chemicals. A sensor monitors performance. UV only addresses microbes, so it works best after sediment filtration on clear water.

Explore →

Well Water Filter (Oxidation): how it works

A chemical-free oxidation system turns dissolved iron, manganese and hydrogen sulfide into particles the media can trap. That targets orange and black staining and the 'rotten egg' smell common in well water.

Explore →

Under-Sink Reverse Osmosis: how it works

Reverse osmosis pushes water through a very fine membrane, plus pre- and post-filters, to reduce a wide range of dissolved contaminants in drinking and cooking water at one faucet.

Explore →

From The Flow